Programmable digital standard servo with titanium gear aand double BB-ed output shaft for general use in all kind of RC models – great for larger model planes, 1:10 RC cars etc. Plastic case with middle aluminium heatsink for perfect cooling under high load.GO-1053MG is programmable using the KAVAN GO servo USB programmer/interface and PC software.Programmable FunctionsServo Angle: Maximal servo rotation angle range setting. The default range is ca 120° within the regular RC signal pulse width range (900~2100 µs); ca 180° within the max. signal pulse width range (500~2500 µs).Servo Neutral: Servo neutral (centre) position setting.Damping Factor: Servo damping setting – adjust the characteristics of the servo when stopping.PWM Power: Adjusts the servo output power. The higher the power, the higher the speed and torque of the servo – indeed also the current consumption will be higher.Sensitivity: Servo sensitivity (Dead Band) setting. The higher sensitivity the narrower the dead band – servo moves only if the change of the signal pulse width is bigger than the dead band width. Too high setting may cause servo jitter in some applications. Range: Ultra High (ca 1 µs dead band) – High (ca 2 µs) – Medium (ca 3 µs) – Low (ca 4 µs)Soft Start: Turns on/off the soft start feature. If ON, the servo goes slowly to the initial position corresponding to the servo signal once the power is switched on.Reverse: Reverses the servo movement direction.Narrow Band: FUTABA SR Mode – only for use with FUTABA radio channels working in the SR mode. Do not turn the option on if you are using a different setting of your FUTABA radio or any other radio.SANWA SSR: SANWA SSR Mode – only for use with SANWA radio channels working in the SSR mode. Do not turn the option on if you are using a different setting of your SANWA radio or any other radio.Lost PPM Protection (Fail-Safe): In the case the control signal from the receiver is lost completely or cannot be decoded correctly (due to interference) the servo can use choose one of three fail-safe modes:(a) Release: No fail-safe protection.(b) Keep Position: Keeps the position corresponding to the last correct control signal.(c) Go Neutral Position: The servo returns to the neutral (1500 µs pulse width) position.Over Load protection: Enables or disables overload protection of the servo in three levels – once the overload conditions last for the pre-set time (in seconds), the output power of the servo is reduced to the corresponding pre-set level (% of the max. power).Default: Restores the factory default setting of the connected servo.Wide input voltage range 4.8-8.4 V (nominal).25T/5.92 mm output shaft.Servo dimensionsStandardServo typeDigitalProgrammableYesThrust at 4.8V [kg/cm]13Thrust at 6.0V [kg/cm]15Thrust at 7.4V [kg/cm]18Thrust at 8.4V [kg/cm]20Speed at 4.8V [s/60st.]0.23Speed at 6.0V [s/60st.]0.21Speed at 7.4V [s/60st.]0.2Speed at 8.4V [s/60st.]0.17Servo gearsTitaniumBall bearings2×High-voltageYesPower supply [V]4.8 – 8.4Length [mm]40Width [mm]20Height [mm]42.3Weight [g]63Intended forAeroplanes,On-road cars,Off-road cars,Boats
